Skip to main content
All CollectionsManuals
Manual: Technagon AC
Manual: Technagon AC

On this page you will find the steps to connect the Technagon AC charger to the E-Flux by Road platform.

Jochem Boot avatar
Written by Jochem Boot
Updated over a week ago

Configuration Requirements

  • Configuration package E-Flux by Road

    • Contains: Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station

  • Installation guide Technagon

  • Laptop with operating systems supported: Windows 11, macOS, Linux.

  • MicroUSB cable

Follow the steps

Step 1: Log in to the Web Interface using the following information:

Step 2: Navigate to the "Network" Settings: Under Network (WAN/Internet), ensure that the Auto (DHCP) option is selected to assign IP automatically, or configure a static IP address as needed or set "Never default" if you want the connection to prioritize cellular communication.

Step 3: Go to the ‘'Communication'' click on the ‘OCPP’' section. Select ''Operator’' as custom. Enter the following urll: ws://ocpp.e-flux.nl/1.6/e-flux

Step 4: Set the authorization key if required for connecting to the backend and ensure the protocol version is set to OCPP-J 1.6 json (this is non-editable).

Step 5: Verify that the Chargebox ID is correctly auto-generated from the device's serial number. Optionally, adjust the Chargebox ID (Template) to match how the charger should identify itself to the back office and then save the settings.

Step 6: Go to the Admin menu and restart the charger to apply the new configuration. Optionally, reboot the system for the settings to take full effect.

If you are the installer of the charging station, go to Step 7, If you are the owner of the charging station, go to step 8.

Step 7: Complete the following steps to activate the station on the E-Flux by Road platform:

  1. Login to your Field Service Account or create a Field Service Account via www.e-flux.io/installer-signup*.

  2. Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.

  3. Click on “Setup charging station”.

  4. Click on Upload Configuration, then click Next.

  5. Choose and define the connector type, and choose “Save Connector Configuration”.

  6. The charging station is now activated and ready to be registered by the owner!

*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.

Step 8: Complete the following steps to register the station on the E-Flux by Road platform:

  1. Ask your installer to complete Step 9 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.

  2. Create an E-Flux by Road account by going to www.e-flux.io/signup.

    • Is this charging station facilitated by your employer? Check your email for the invitation.

  3. Follow the steps to add the location and register your charging station.

  4. Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.

  5. The charging station is now registered and ready to be used!

The charging station is now connected to the E-Flux by Road platform!


Did this answer your question?