Manual: ADS-TEC ChargePost | E-Flux by Road Help Center

Configuration Requirements

Configuration package E-Flux by Road
- Contains: Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station
Installation manual ChargePost
Configuration device: Windows laptop with preinstalled browser
LAN Cable

Step 1: Use the Installation manual of the ChargePost to safely complete the installation of the charger.

Step 2: Configure the network settings of your laptop as follows:

Step 3: Use a LAN cable to connect the laptop to the service port on the PLC of the charger.

Step 4: Open your browser and enter the following IP address to gain access to the web interface of the charger: 172.17.10.100.8080

Note: contact the ADS-TEC support team if the web interface does not appear automatically.

Step 5: Use the login details from the product training to enter the Service HMI.

Step 6: Select the Network menu and select Routers to configure the APN settings of the U12 router.

Step 7: Select Set Credentials and fill in the following APN name to set up the connection with an E-Flux by Road sim card: m2m.services

Note: the pin, username and password are not required to setup a connection with an E-Flux by Road sim card.

Step 8: Select the OCPP menu and enter the following values:

Note: the other OCPP settings can be left empty.

Step 9: Save the settings and reboot the charger.

If you are the installer of the charging station, go to Step 10. If you are the owner of the charging station, go to step 11.

Step 10: Complete the following steps to activate the station on the E-Flux by Road platform:

Login to your Field Service Account or create a Field Service Account via www.e-flux.io/installer-signup*.
Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.
Click on “Setup charging station”.
Click on Upload Configuration, then click Next.
Choose and define the connector type, and choose “Save Connector Configuration”.
The charging station is now activated and ready to be registered by the owner!

*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.

Step 11: Complete the following steps to register the station on the E-Flux by Road platform:

Ask your installer to complete Step (previous step) to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.
Create an E-Flux by Road account by going to www.e-flux.io/signup.
- Is this charging station facilitated by your employer? Check your email for the invitation.
Follow the steps to add the location and register your charging station.
Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.
The charging station is now registered and ready to be used!