Skip to main content
All CollectionsManuals
Manual: Weidmüller
Manual: Weidmüller

On this page you will find the steps to connect the Weidmüller AC SMART charger to the E-Flux by Road platform.

Jochem Boot avatar
Written by Jochem Boot
Updated over 3 weeks ago

Configuration Requirements

  • Configuration package E-Flux by Road

    • Contains: Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station

  • Installation manual AC SMART ECO, VALUE & ADVANCED

  • Configuration device: laptop

  • Ethernet cable

Follow the steps

Step 1: Connect the charger to the local network via a LAN cable according to chapter 9.1 of the installation manual.

Step 2: Press the Win+R buttons on your laptop and enter ncpa.cpl in the execute window.

Step 3: Right click on Ethernet settings and select Properties.

Step 4: Select Internet Protocol Version 4 (TCP/IPv4) and click on Properties.

Step 5: Select Use the following IP address and enter an IP address between 192.168.0.2 and 192.168.0.254 (192.168.0.8 is reserved by the charger). Configure the Subnet mask on 255.255.255.0 and press OK.

Step 6: Open a web browser and enter the following address: http://192.168.0.8. Enter the following login credentials to gain access to the web server:

  • Role: Admin

  • Password: zyVt45Nv0y

Step 7: Navigate to Network/Cloud and and enable OCPP 1.6J. Select the desired Interface and configure the network settings accordingly. Enter the following values to setup the connection with E-Flux by Road:

  • Portal address: ocpp.e-flux.nl

  • Portal port: 80

  • Portal path: 1.6/e-flux/ChargeBoxSerialNumber → Replace ChargeBoxSerialNumber with the unique serial number of the charger

Step 8: Click on Save and reboot the charger.

If you are the installer of the charging station, go to Step 9. If you are the owner of the charging station, go to step 10.

Step 9: Complete the following steps to activate the station on the E-Flux by Road platform:

  1. Login to your Field Service Account or create a Field Service Account via www.e-flux.io/installer-signup*.

  2. Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.

  3. Click on “Setup charging station”.

  4. Click on Upload Configuration, then click Next.

  5. Choose and define the connector type, and choose “Save Connector Configuration”.

  6. The charging station is now activated and ready to be registered by the owner!

*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.

Step 10: Complete the following steps to register the station on the E-Flux by Road platform:

  1. Ask your installer to complete Step 9 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.

  2. Create an E-Flux by Road account by going to www.e-flux.io/signup.

    • Is this charging station facilitated by your employer? Check your email for the invitation.

  3. Follow the steps to add the location and register your charging station.

  4. Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.

  5. The charging station is now registered and ready to be used!

The charging station is now connected to the E-Flux by Road platform!

Did this answer your question?