Skip to main content

Manual: NexBlue

On this page you will find the steps to connect the NexBlue Edge charger to the E-Flux by Road platform.

Jochem Boot avatar
Written by Jochem Boot
Updated this week

Configuration Requirements

Follow the steps

Step 1: Open the NexBlue Partner APP for Installers and create or configure a location:

  • If you want to configure E-Flux to a New Location

    • Tap Start configuration or Add new location in the Locations section

  • If you want to configure E-Flux to an Existing Location

    • Tap Locations

    • Select the Location that you will operate

    • Tap Settings

Step 2: Tap Operator

Step 3: Select E-Flux

Step 4: Tap Activate the operator to jump to the location settings interface which shows the Operator is E-Flux.

Step 5: Resolve the issues if necessary and retry the configuration if any chargers failed.

Step 6: Take note of the Serial Number of the charger in the location.

If you are the installer of the charging station, go to Step 7. If you are the owner of the charging station, go to step 8.

Step 7: Complete the following steps to activate the station on the E-Flux by Road platform:

  1. Login to your Field Service Account or create a Field Service Account via www.e-flux.io/installer-signup*.

  2. Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.

  3. Click on “Setup charging station”.

  4. Click on Upload Configuration, then click Next.

  5. Choose and define the connector type, and choose “Save Connector Configuration”.

  6. The charging station is now activated and ready to be registered by the owner!

*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.

Step 8: Complete the following steps to register the station on the E-Flux by Road platform:

  1. Ask your installer to complete Step 7 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.

  2. Create an E-Flux by Road account by going to www.e-flux.io/signup.

    • Is this charging station facilitated by your employer? Check your email for the invitation.

  3. Follow the steps to add the location and register your charging station.

  4. Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.

  5. The charging station is now registered and ready to be used!

The charging station is now connected to the E-Flux by Road platform!

Did this answer your question?