Skip to main content

Manual: QPOWER

On this page you will find the steps to connect the QPOWER charger to the E-Flux by Road platform.

Jochem Boot avatar
Written by Jochem Boot
Updated over 3 weeks ago

Configuration Requirements

  • Configuration package E-Flux by Road

    • Contains: Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station

  • Configuration device: laptop

  • UTP cable

Follow the steps

Step 1: Switch off the charger's power supply and open the front cover of the charging station.

Step 2: On the motherboard, set the N1N2 (5/6) dial switch to ON as shown in the picture below.

Step 3: Plug one end of a network cable into the WLAN port on the motherboard and connect the other end to your laptop. Switch the charger's power supply back on once the cable is connected.

Step 4: Set up a Static IP address on your macOS or Windows 10 laptop:

  • MacOS:

  • Windows 10:

Step 5: Enter the following web address in your browser to enter the web page of the charger: http://192.168.1.253/index.html. Login with the following credentials:

  • Username: root

  • Password: root@123456

Step 6: Navigate to the Configuration menu and change the CsmsWebsocketUrl to:

  • ws://ocpp.road.io/e-flux -> When using a white Road SIM card or another connection method.

  • ws://ocpp-internal.road.io/e-flux -> When using a purple Road SIM card.

*If a Road SIM card is used to set up the connection, the SimCardAPN must be set to:

  • m2m.services -> When using a purple Road SIM card:

  • road.io -> When using a purple Road SIM card:

Step 7: Go to the Network menu and select SWITCH_CODE as the server network method.

Step 8: Set the N1N2 (5/6) selector switch on the motherboard according to the network method used:

  • WiFi:

  • 4G:

  • LAN:

Step 9: Reboot the charger to finish the configuration process.

If you are the installer of the charging station, go to Step 10. If you are the owner of the charging station, go to step 11.

Step 10: Complete the following steps to activate the station on the E-Flux by Road platform:

  1. Login to your Field Service Account or create a Field Service Account via www.e-flux.io/installer-signup*.

  2. Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.

  3. Click on “Setup charging station”.

  4. Click on Upload Configuration, then click Next.

  5. Choose and define the connector type, and choose “Save Connector Configuration”.

  6. The charging station is now activated and ready to be registered by the owner!

*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.

Step 11: Complete the following steps to register the station on the E-Flux by Road platform:

  1. Ask your installer to complete Step 10 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.

  2. Create an E-Flux by Road account by going to www.e-flux.io/signup.

    • Is this charging station facilitated by your employer? Check your email for the invitation.

  3. Follow the steps to add the location and register your charging station.

  4. Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.

  5. The charging station is now registered and ready to be used!

The charging station is now connected to the E-Flux by Road platform!

Did this answer your question?