Skip to main content

Manual: EATON Green Motion Duo

On this page you will find the steps to connect the EATON Green Motion Duo charger to the E-Flux by Road platform.

Jochem Boot avatar
Written by Jochem Boot
Updated over a week ago

Configuration Requirements

  • Configuration package E-Flux by Road

    • Contains: Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station

  • EATON Green Motion Duo Installation Manual

  • Configuration device: mobile phone

Follow the steps

Step 1: Enable WIFI on your phone and turn the EV charger OFF and ON. During the first 30 minutes after power-up or restart, the GM Duo Master creates a WIFI hot spot.

Step 2: Scan the QR code (or retype the SSID/Passphrase) and connect to the WIFI network which is provided by the GM Duo Master. The welcome commissioning screen should appear automatically in your browser.

Step 3: Press Next to start the commissioning process and accept the security warning by pressing Advanced and Proceed to unsafe IP address.

Step 4: Change the default password of the EV charger to continue.

Step 5: Navigate to the first screen of the commissioning wizard, select the internet connection method according to the local network configuration and configure the details of the selected method.

Step 6: On the Settings/OCPP server page press Edit OCPP Server button and enable the OCPP communication.

Step 7: Enter the following credentials:

  • CSMS (Backend): Custom

  • Protocol: OCPP 1.6j

  • Charge Point ID: ‘enter the ChargeBoxSerialNumber’

  • Server Address:

    • When using a white Road SIM card or another connection method: ws://ocpp.road.io/e-flux

    • When using a purple Road SIM card: ws://ocpp-internal.road.io/e-flux

  • Security profile: 2

Step 8: Press the Save and Reconnect button.

If you are the installer of the charging station, go to Step 9. If you are the owner of the charging station, go to step 10.

Step 9: Complete the following steps to activate the station on the E-Flux by Road platform:

  1. Login to your Field Service Account or create a Field Service Account via www.e-flux.io/installer-signup*.

  2. Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.

  3. Click on “Setup charging station”.

  4. Click on Upload Configuration, then click Next.

  5. Choose and define the connector type, and choose “Save Connector Configuration”.

  6. The charging station is now activated and ready to be registered by the owner!

*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.

Step 10: Complete the following steps to register the station on the E-Flux by Road platform:

  1. Ask your installer to complete Step 9 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.

  2. Create an E-Flux by Road account by going to www.e-flux.io/signup.

    • Is this charging station facilitated by your employer? Check your email for the invitation.

  3. Follow the steps to add the location and register your charging station.

  4. Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.

  5. The charging station is now registered and ready to be used!

The charging station is now connected to the E-Flux by Road platform!

Did this answer your question?