Skip to main content

Manual: Hager Witty Park 2

On this page you will find the steps to connect the Hager Witty Park 2 charger to the E-Flux by Road platform.

Jochem Boot avatar
Written by Jochem Boot
Updated this week

Configuration Requirements

  • Configuration package E-Flux by Road

    • Contains: Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station

  • Installation Manual Witty Park 2

  • Configuration device: laptop

Follow the steps

Step 1: Hold the RFID tag in front of the RFID reader for at least 7 seconds to activate the Wi-Fi hotspot. A blue LED light will indicate that the hotspot has been activated successfully.

Step 2: Connect your laptop to the Wi-Fi network that has the serial number of the charger as the SSID: Witty-xxxxxx (the last 6 digits of the serial number).

Step 3: Open your web browser and enter the IP address or computer host name of the charger in the search bar:

  • IP address: 192.168.3.5

  • Computer host name: Hager.local

Step 4: Enter the login credentials that are shown on the label on the side of the charger.

  • Username: admin

  • Password: the first 4 digits of the serial number

Step 5: Open the Charging station tab, select Network and configure the preferred connection method.

Note: If an E-Flux by Road SIM card is used, go to the network settings and activate the mobile data connection. Here you can enter the following APN to activate the connection:

  • When using a white Road SIM card or another connection method: m2m.services

  • When using a purple Road SIM card: road.io

Step 6: Open the Access management tab, select Access methods and enable Controlled access.

Step 7: Select Charging point operator and enter the following values:

  • Charging point operator address:

    • When using a white Road SIM card or another connection method: ws://ocpp.road.io/e-flux

    • When using a purple Road SIM card: ws://ocpp-internal.road.io/e-flux

  • OCPP ID: Enter the serial number of the charger

  • Authentication type: Basic

  • Password: Not required

If you are the installer of the charging station, go to Step 8. If you are the owner of the charging station, go to step 9.

Step 8: Complete the following steps to activate the station on the E-Flux by Road platform:

  1. Login to your Field Service Account or create a Field Service Account via www.e-flux.io/installer-signup*.

  2. Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.

  3. Click on “Setup charging station”.

  4. Click on Upload Configuration, then click Next.

  5. Choose and define the connector type, and choose “Save Connector Configuration”.

  6. The charging station is now activated and ready to be registered by the owner!

*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.

Step 9: Complete the following steps to register the station on the E-Flux by Road platform:

  1. Ask your installer to complete Step 8 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.

  2. Create an E-Flux by Road account by going to www.e-flux.io/signup.

    • Is this charging station facilitated by your employer? Check your email for the invitation.

  3. Follow the steps to add the location and register your charging station.

  4. Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.

  5. The charging station is now registered and ready to be used!

The charging station is now connected to the E-Flux by Road platform!

Did this answer your question?