Configuration Requirements
Configuration package E-Flux by Road
Contains: Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station
Installation Guide UrbanBox
Configuration device: laptop with Windows 11 installed
Ethernet cable
Follow the steps
Step 1: Connect the Ethernet cable to the switch that is underneath the controller.
Step 2: Select Network & Internet in your laptop settings menu and choose option Ethernet.
Step 3: Activate IPv4 and choose an IP Address in the range 192.168.2.200 to 192.168.2.220 (eg:192.168.2.200).
Step 4: Open the browser and insert the address: http://192.168.2.2:8080/index.html
Step 5: Select the menu Config and then the option Software Properties-RW.
Step 6: Look for the Isk.evse.Cfg.dl.uri parameter and click on it.
Step 7: Inside the Box Value write one of the following server URL’S:
When using a white Road SIM card or another connection method: ws://ocpp.road.io/e-flux
When using a purple Road SIM card: ws://ocpp-internal.road.io/e-flux
Step 8: Navigate back to the Home page and select Commands in the Status dropdown menu.
Step 9: Click on RESET SW to reboot the charger.
If you are the installer of the charging station, go to Step 10. If you are the owner of the charging station, go to step 11.
Step 10: Complete the following steps to activate the station on the E-Flux by Road platform:
Login to your Field Service Account or create a Field Service Account via www.e-flux.io/installer-signup*.
Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.
Click on “Setup charging station”.
Click on Upload Configuration, then click Next.
Choose and define the connector type, and choose “Save Connector Configuration”.
The charging station is now activated and ready to be registered by the owner!
*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.
Step 11: Complete the following steps to register the station on the E-Flux by Road platform:
Ask your installer to complete Step 10 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.
Create an E-Flux by Road account by going to www.e-flux.io/signup.
Is this charging station facilitated by your employer? Check your email for the invitation.
Follow the steps to add the location and register your charging station.
Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.
The charging station is now registered and ready to be used!