Manual: Vestel

On this page you will find the steps to connect the Vestel charger to the E-Flux by Road platform.

Written by Sjoerd Kortekaas
Updated over a week ago

Configuration Requirements

  • Configuration package E-Flux by Road

    • Contains: EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station

  • Configuration device: laptop/mobile phone

  • WiFi connection

Follow the steps:

Step 1: You will need to connect to the WiFi (hotspot), which is emitted from your charge point. All EVC04-Models have a WiFi hotspot feature which is enabled by default. The following credentials can be used to access the internet signal of your charge point:

  • WiFi name or SSID: Serial number of your charge point

  • Password: Chargebox-ID

Step 2: After connecting to the "Wi-Fi Hotspot” network, you can open your web browser from a computer or mobile device. In the URL section, enter, which is the IP-address of the charging station.

Step 3: Once you’ve entered the URL, you will be forwarded to the WebUI login page. Use the following credentials to login to the web interface:

  • User Name: admin

  • Password: admin

Step 4: Once in the WebUI, go to OCPP settings and enable the OCPP connection. After that you have to fill in the following details:

  • Central system address: ws://

  • Charge Point ID: *enter your charge point ID here*

Step 5: Scroll down to the field AuthorizationKey and fill in FFFFFFFF as shown in the screenshot below.

Step 6: Click on Save.

Step 7: Now it is time to connect your charge point to the internet. To do so, navigate to the Network interfaces section and select WIFI. Fill in the following details:

  • SSID: *your WiFi’s exact name*

  • Password: *your WiFi's password*

Step 8: After you have filled in the information, please click on Save.

If you are the installer of the charging station, go to step 9. If you are the owner of the charging station, go to step 10.

Step 9: Complete the following steps to activate the station on the E-Flux by Road platform:

  1. Login to your Field Service Account or create a Field Service Account via*.

  2. Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.

  3. Click on “Setup charging station”.

  4. Click on Upload Configuration, then click Next.

  5. Choose and define the connector type, and choose “Save Connector Configuration”.

  6. The charging station is now activated and ready to be registered by the owner!

*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.

Step 10: Complete the following steps to register the station on the E-Flux by Road platform:

  1. Ask your installer to complete Step 9 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.

  2. Create an E-Flux by Road account by going to

    • Is this charging station facilitated by your employer? Check your email for the invitation.

  3. Follow the steps to add the location and register your charging station.

  4. Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.

  5. The charging station is now registered and ready to be used!

The charging station is now connected to the E-Flux by Road platform!

Did this answer your question?