All Collections
Manuals
Manual: Schneider Electric
Manual: Schneider Electric

On this page you will find the steps to connect the Schneider charger to the E-Flux by Road platform.

S
Written by Sjoerd Kortekaas
Updated this week

On this page you will find the steps to connect the Schneider charger to the E-Flux by Road platform.

Configuration Requirements

  • Configuration package E-Flux by Road.

    • Contains: Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station.

  • Online installation guide.

  • Configuration device: laptop.

  • UTP cable.

Follow the steps

Step 1: Configuring the charge point

Scan the QR code on your charge point, which will direct you here for a step-by-step guide for Schneider charging box installation. Click on Documentation and then Product Documentation. Scroll down to an instruction sheet and click on: EVlink Smart Wallbox - EVB1A22P - Installation guide. On page 35 you will find all the steps for configuring your charge point.

Step 2. Connect your computer to the charge point by an Ethernet cable

After you have connected your computer to the charge point, set the static IP address properties as follows:

Step 3. Open your browser and enter the URL

Enter the URL http://192.168.0.102 and log in with the following credentials:

  • User name: admin

  • Password: ADMIN

Step 4. Click on Supervision

Once you are there, paste the backend URL to the Supervision URL: “ws://ocpp.e-flux.nl/1.6/e-flux”. Afterwards, insert the serial number of your charge point (Charging station ID).

Step 5. Make sure your charge point has Internet connection

Reboot your charge point and wait 30 seconds to refresh your window.

If you are the installer of the charging station, go to step 6. If you are the owner of the charging station, go to step 7.

Step 6: Complete the following steps to activate the station on the E-Flux by Road platform:

  1. Login to your Field Service Account or create a Field Service Account via www.e-flux.io/installer-signup*.

  2. Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.

  3. Click on “Setup charging station”.

  4. Click on Upload Configuration, then click Next.

  5. Choose and define the connector type, and choose “Save Connector Configuration”.

  6. The charging station is now activated and ready to be registered by the owner!

*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.

Step 7: Complete the following steps to register the station on the E-Flux by Road platform:

  1. Ask your installer to complete Step 6 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.

  2. Create an E-Flux by Road account by going to www.e-flux.io/signup.

    • Is this charging station facilitated by your employer? Check your email for the invitation.

  3. Follow the steps to add the location and register your charging station.

  4. Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.

  5. The charging station is now registered and ready to be used!

The charging station is now connected to the E-Flux by Road platform!


Did this answer your question?