All Collections
Manual: Schneider EV Link Pro
Manual: Schneider EV Link Pro

On this page you will find the steps to connect the Schneider EVlink Pro charger to the E-Flux by Road back office platform.

Written by Sjoerd Kortekaas
Updated over a week ago

Configuration Requirements

  • Configuration package E-Flux by Road.

    • Contains: EVSE ID and configuration manual for the installer and owner.

  • Schneider eSetup configuration app.

  • Configuration device: mobile phone.

Follow the steps:

Step 1: Download the eSetup app from the Apple appstore or Google playstore. Follow the instructions and accept the user agreement. After this you can create a account and log in. Now allow the acces to local devices in the network and to bluetooth.

Step 2: Choose the EVlink Pro AC in the main menu to start searching for the charger. Your charger will apear with active bluetooth. Click on your charging station and confirm the connection.

Note: The Bluetooth connection is only active for 2 hours after being turned on. After that it can be reactivated with an admin card.

Step 3: Enter a 6-digit code to set the pin-code for your charger.

Note: 123456 isn’t an option.

After that you will be able to connect to your charging station with the pin-code you’ve just set. As soon as the connection was established successfully you will have all of the charger’s features at your disposal.

Note: The first card you use will automatically become the admin card and will be able to turn Bluetooth on and introduce other charge cards to the charger.

Step 4: Navigate to Configuration. After that click on Backend Configuration

Step 5: To connect the charger to the backend it must be connected to the Internet via a modem or network.

  • In the backend URL enter - ws://

  • The charger ID is unique and should look like this - [EVlink Pro AC] - [20105]. Instead of [20105] please enter the ID of your charger.

  • Click on ON on top in the Backend connection field.

  • Choose All cards will be accepted in the Offline mode part.

If you are the installer of the charging station, go to Step 6. If you are the owner of the charging station, go to step 7.

Step 6: Complete the following steps to activate the station on the E-Flux by Road platform:

  1. Login to your Field Service Account or create a Field Service Account via*.

  2. Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.

  3. Click on “Setup charging station”.

  4. Click on Upload Configuration, then click Next.

  5. Choose and define the connector type, and choose “Save Connector Configuration”.

  6. The charging station is now activated and ready to be registered by the owner!

*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.

Step 7: Complete the following steps to register the station on the E-Flux by Road platform:

  1. Ask your installer to complete Step 7 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.

  2. Create an E-Flux by Road account by going to

    • Is this charging station facilitated by your employer? Check your email for the invitation.

  3. Follow the steps to add the location and register your charging station.

  4. Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.

  5. The charging station is now registered and ready to be used!

The charging station is now connected to the E-Flux by Road platform!

Did this answer your question?