EN+

In this guide, we will show you how to install an EN+ charging station easily and quickly. Below you will find everything you need.

S
Written by Sjoerd Kortekaas
Updated this week

Guide EN+

Step 1. Network configuration

Wifi Connection

  • Turn on WiFi and Airplane mode on your phone.

  • Select the hotspot of your charge point, it should start with “SN…” and the serial number of your charger.

  • Enter WiFi password (by default it is - admin123)

Step 2. Log in

  • Select a browser

  • Enter your device’s IP address (by default it is - 192.168.4.1)

  • Enter a 4-digit network password (PIN number). The PIN number of your charger can be found on the last page of your user manual.

Note: Please, double check that the hotspot you are connected to is correct, otherwise you will not be able to enter the login interface.

Step 3. WiFi setup

  • Click on “Network Setup”

  • Then click on “WiFi”.You can select the WiFi name that you want to connect to in here, by selecting “Other”and entering the WiFi information (if your WiFi is not on the list). Here you also need to change the server address to - “ws://ocpp.e-flux.nl/1.6/e-flux”. After you enter the server address, the SN will display automatically.

Note: After setting WiFi up, select the charge point hotspot again and enter its password again.

Step 4. Verifying network connectivity

After logging in again, please make sure the WiFi strength is “Excellent”, Server communication is “Connected”, and the network status is “Online”. If the WiFi strength is “Poor”, please try to change the WiFi. If the server communication is “Disconnected” or the network status shows “Offline”, please try to reset network settings, then repeat Steps 2 and 3.

The charging station is now linked to the Road platform!

Did this answer your question?