Skip to main content
All CollectionsManuals
Manual: EVBOX TRONIQ Modular
Manual: EVBOX TRONIQ Modular

On this page you will find the steps to connect the EVBOX TRONIQ Modular charger to the E-Flux by Road platform.

Sjoerd Kortekaas avatar
Written by Sjoerd Kortekaas
Updated over a week ago

Configuration Requirements

  • Configuration package E-Flux by Road.

    • Contains: Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station.

  • Installation guide EVBOX TRONIQ Modular.

Follow the steps:

Step 1: When you purchase the EVBOX TRONIQ Modular and want to pair with E-Flux by Road, this will largely be taken care of by EVBOX.

Step 2: Provide EVBOX with the information below:

  • Name of the Backend: E-Flux backend.

  • Backend OCPP connection URL: ws://

Step 3: Indicate whether the internet connection is via SIM card or Ethernet.

  • In the case of a SIM card, provide the following information:

    • Please inform/confirm the SIM card is provided by backend supplier: yes.

    • PIN code of the SIM card if this can already be shared: leave empty.

    • APN of the SIM card: “”.

    • APN username/password if applicable: leave empty.

  • In the case of Ethernet connection:

    • Charger IP address: DHCP.

    • Network subnet mask.

    • Network Gateway IP address.

    • Network DNS IP address.

Step 4: Once EVBOX has confirmed the charger is connected to the E-Flux by Road platform you can advance to the next step.

If you are the installer of the charging station, go to step 5. If you are the owner of the charging station, go to step 6.

Step 5: Complete the following steps to activate the station on the E-Flux by Road platform:

  1. Login to your Field Service Account or create a Field Service Account via*.

  2. Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.

  3. Click on “Setup charging station”.

  4. Click on Upload Configuration, then click Next.

  5. Choose and define the connector type, and choose “Save Connector Configuration”.

  6. The charging station is now activated and ready to be registered by the owner!

*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.

Step 6: Complete the following steps to register the station on the E-Flux by Road platform:

  1. Ask your installer to complete Step 5 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.

  2. Create an E-Flux by Road account by going to

    • Is this charging station facilitated by your employer? Check your email for the invitation.

  3. Follow the steps to add the location and register your charging station.

  4. Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.

  5. The charging station is now registered and ready to be used!

The charging station is now connected to the E-Flux by Road platform!

Did this answer your question?