All Collections
Manuals
Manual: Charge Amps
Manual: Charge Amps

On this page you will find the steps to connect the Charge Amps charger to the E-Flux by Road platform.

S
Written by Sjoerd Kortekaas
Updated over a week ago

On this page you will find the steps to connect the Charge Amps charger (Aura & Halo) to the E-Flux by Road platform.

Configuration Requirements

  • Configuration package E-Flux by Road

    • Contains: EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station

  • User manual ChargeAmps:

  • Configuration device: laptop or mobile phone

Important: The E-Flux by Road SIM card does not work with the ChargeAmps charger. Connect the charger via WIFI/LAN or with the included ChargeAmps SIM card.

Follow the steps

Step 1: Follow the Charge Amps installation guide and connect the charging station to the internet via WIFI/LAN or via the ChargeAmps SIM card.

Step 2: Login to your ChargeAmps partner-account. No login yet? Go to the following link to create an account: https://my.charge.space/partner/#/registerPartner (account acceptance may take up to 24 hours).

Step 3: Follow the ''Installation Wizard'' in the partner-account and configure the station(s) and if necessary the Amp-Guard loadbalancer.

Step 4: Send an email to [email protected] and ask them to connect the charger to the backoffice URL ws://ocpp.e-flux.nl/1.6/e-flux/. ChargeAmps will configure the charger on the E-Flux by Road platform. After they have done this please continue with the following steps.

If you are the installer of the charging station, go to step 5. If you are the owner of the charging station, go to step 6.

Step 5: Complete the following steps to activate the station on the E-Flux by Road platform:

  1. Login to your Field Service Account or create a Field Service Account via www.e-flux.io/installer-signup*.

  2. Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.

  3. Click on “Setup charging station”.

  4. Click on Upload Configuration, then click Next.

  5. Choose and define the connector type, and choose “Save Connector Configuration”.

  6. The charging station is now activated and ready to be registered by the owner!

*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.

Step 6: Complete the following steps to register the station on the E-Flux by Road platform:

  1. Ask your installer to complete Step 5 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.

  2. Create an E-Flux by Road account by going to www.e-flux.io/signup.

    • Is this charging station facilitated by your employer? Check your email for the invitation.

  3. Follow the steps to add the location and register your charging station.

  4. Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.

  5. The charging station is now registered and ready to be used!

The charging station is now connected to the E-Flux by Road platform!

Did this answer your question?