Configuration Requirements
Configuration package E-Flux by Road
Contains: Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station
Laptop
UTP cable
Follow the steps:
Step 1: Make sure to have a local connection with the charging station via UTP
Go to http://ev3000.local:3000
Step 2: Log in using the following credentials:
Username: operator
Password: blitzoperator91500591
Step 3: Click on Quick setup
Step 4: Connect the station to the Internet (see image below)
You can do this one of these two ways:
UTP:
Click on DHCP
The IP address and the subnet mask will be filled in automatically;
Enter the Gateway. You do this by copying your IP address and replacing the last number of it with a 1.
For example: If your IP address is 192.168.2.36, delete “36” and write “1” instead. Your Gateway should then be - 192.168.2.1
OR
Sim-card:
Enter SIM card details:
Sim Pin – leave this field empty;
APN – enter – m2m.services
Save the changes.
Step 5: Go to Charge Points and indicate which charge points you want to connect to the OCPP or click on Configure All
Step 6: Choose E-Flux as the OCPP provider
Step 7: Click Save
If you are the installer of the charging station, go to step 8. If you are the owner of the charging station, go to step 9.
Step 8: Complete the following steps to activate the station on the E-Flux by Road platform:
Login to your Field Service Account or create a Field Service Account via www.e-flux.io/installer-signup*.
Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.
Click on “Setup charging station”.
Click on Upload Configuration, then click Next.
Choose and define the connector type, and choose “Save Connector Configuration”.
The charging station is now activated and ready to be registered by the owner!
*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.
Step 9: Complete the following steps to register the station on the E-Flux by Road platform:
Ask your installer to complete Step 8 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.
Create an E-Flux by Road account by going to www.e-flux.io/signup.
Is this charging station facilitated by your employer? Check your email for the invitation.
Follow the steps to add the location and register your charging station.
Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.
The charging station is now registered and ready to be used!