Skip to main content
All CollectionsManuals
Manual: Alpitronic
Manual: Alpitronic

On this page you will find the steps to connect the Alpitronic charger to the E-Flux by Road platform.

Sjoerd Kortekaas avatar
Written by Sjoerd Kortekaas
Updated over a week ago

Configuration Requirements

  • Configuration package E-Flux by Road

    • Contains: Sim card, EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station

  • Online guide Alpitronic Hypercharger

  • Laptop equipped with a Windows operating system

  • UTP cable

Follow the steps

Step 1: Connect your laptop to the Alpitronic with a UTP cable to enter the interface.

Step 2: Go to: 192.168.1.100 via your browser.

Step 3: Go to Network, SIM Configuration and enter the APN of E-Flux by Road: m2m.services

Step 4: Go to OCPP configuration.

Step 5: Go to BOOT.INI Configuration.

a. Enter the E-Flux URL (ws://ocpp.e-flux.nl/1.6/e-flux) and everything else exactly as shown in the image below.

b. Click Save.

If you are the installer of the charging station, go to step 6. If you are the owner of the charging station, go to step 7.

Step 6: Complete the following steps to activate the station on the E-Flux by Road platform:

  1. Login to your Field Service Account or create a Field Service Account via www.e-flux.io/installer-signup*.

  2. Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.

  3. Click on “Setup charging station”.

  4. Click on Upload Configuration, then click Next.

  5. Choose and define the connector type, and choose “Save Connector Configuration”.

  6. The charging station is now activated and ready to be registered by the owner!

*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.

Step 7: Complete the following steps to register the station on the E-Flux by Road platform:

  1. Ask your installer to complete Step 6 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.

  2. Create an E-Flux by Road account by going to www.e-flux.io/signup.

    • Is this charging station facilitated by your employer? Check your email for the invitation.

  3. Follow the steps to add the location and register your charging station.

  4. Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.

  5. The charging station is now registered and ready to be used!

The charging station is now connected to the E-Flux by Road platform!


Did this answer your question?