Configuration Requirements
Configuration package E-Flux by Road.
Contains: Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station.
Mobile phone or laptop.
Peblar quick start guide hard-copy.
Peblar full manual (optional, can be found online).
Follow the steps:
Step 1: Connect your phone or laptop to the hostname of the charger
You can directly scan the QR code on the left side of the commissioning label with your phone, or connect to the hostname (first row on the label) and insert the WLAN password (second row on the label).
The log-in settings are found on the quick start guide located in the packaging of the Peblar charger, located on position (1) shown in the figure below.
Step 2: Go to the Peblar Config page
Go to the config page URL of the Peblar charger in your web browser. This URL is located on the third row of the commissioning label. The laptop or phone should show the screen below.
Step 3: Configure the WLAN settings
Configure the WLAN settings in the web interface by selecting your home network and entering your credentials of this network. A network connection is required to connect the charger to the E-Flux by Road backend.
Step 4: Configure the installation settings
Configure the current limit, connected phases and load balancing based on the electrical installation and press Next afterwards.
Step 5: Connect the charger to the E-Flux back office URL
Select Managed in the authorization tab. Then, select E-Flux from the drop-down menu. Please note that Peblar only supports secure websocket connections (wss://)! Select save and press next.
Step 6: Finish the configuration
FInish the configuration and reboot the charger.
If you are the installer of the charging station, go to step 7. If you are the owner of the charging station, go to step 8.
Step 7: Complete the following steps to activate the station on the E-Flux by Road platform:
Login to your Field Service Account or create a Field Service Account via www.e-flux.io/installer-signup*.
Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.
Click on “Setup charging station”.
Click on Upload Configuration, then click Next.
Choose and define the connector type, and choose “Save Connector Configuration”.
The charging station is now activated and ready to be registered by the owner!
*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.
Step 8: Complete the following steps to register the station on the E-Flux by Road platform:
Ask your installer to complete Step 7 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.
Create an E-Flux by Road account by going to www.e-flux.io/signup.
Is this charging station facilitated by your employer? Check your email for the invitation.
Follow the steps to add the location and register your charging station.
Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.
The charging station is now registered and ready to be used!
The charging station is now connected to the E-Flux by Road platform!