On this page you will find the steps to connect the Autel DC Fast charger to the E-Flux by Road platform. (Please keep in mind, Autel connects the DC chargers to E-Flux by Road themselves remotely).
Configuration package E-Flux by Road
Contains: EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station
Follow the steps:
Step 1: Get in touch with your contact at Autel and share the following backoffice URL with them: ws://ocpp.e-flux.nl/1.6/e-flux.
Step 2: Once Autel gives confirmation that it has been converted, you can proceed to the last two steps of this manual.
If you are the installer of the charging station, go to step 3. If you are the owner of the charging station, go to step 4.
Step 3: Complete the following steps to activate the station on the E-Flux by Road platform:
Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.
Click on “Setup charging station”.
Click on Upload Configuration, then click Next.
Choose and define the connector type, and choose “Save Connector Configuration”.
The charging station is now activated and ready to be registered by the owner!
*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.
Step 4: Complete the following steps to register the station on the E-Flux by Road platform:
Ask your installer to complete Step 3 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.
Create an E-Flux by Road account by going to www.e-flux.io/signup.
Is this charging station facilitated by your employer? Check your email for the invitation.
Follow the steps to add the location and register your charging station.
Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.
The charging station is now registered and ready to be used!