All Collections
Manuals
Manual: Delta Electronics
Manual: Delta Electronics

On this page you will find the steps to connect the Delta Electronics Charger to the E-Flux by Road platform.

Jochem Boot avatar
Written by Jochem Boot
Updated over a week ago

Configuration Requirements

  • Configuration package E-Flux by Road

    • Contains: Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station

  • Installation guide Delta Electronics

Follow the steps

Step 1: Send an email to [email protected] with the request to create a configuration file to connect the Delta charger to the E-Flux by Road backend. Road will create the configuration file and share it with the installer or customer.

Step 2: Format a USB to FAT32 and upload the configuration file to the USB.

Step 3: Insert the USB into the charging station and wait until the configuration file is uploaded.

Step 4: Remove the USB from the charging station.

In case you want to configure another Delta charger to the E-Flux by Road backend, please follow the following steps:

  • Open the configuration file

  • Change the Chargebox Identity to the unique serial number of the charger (or another EVSE-ID)

  • Follow step 2 to 4 of this manual again

If you are the installer of the charging station, go to Step 5. If you are the owner of the charging station, go to step 6.

Step 5: Complete the following steps to activate the station on the E-Flux by Road platform:

  1. Login to your Field Service Account or create a Field Service Account via www.e-flux.io/installer-signup*.

  2. Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.

  3. Click on “Setup charging station”.

  4. Click on Upload Configuration, then click Next.

  5. Choose and define the connector type, and choose “Save Connector Configuration”.

  6. The charging station is now activated and ready to be registered by the owner!

*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.

Step 6: Complete the following steps to register the station on the E-Flux by Road platform:

  1. Ask your installer to complete Step 5 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.

  2. Create an E-Flux by Road account by going to www.e-flux.io/signup.

    • Is this charging station facilitated by your employer? Check your email for the invitation.

  3. Follow the steps to add the location and register your charging station.

  4. Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.

  5. The charging station is now registered and ready to be used!

The charging station is now connected to the E-Flux by Road platform!

Did this answer your question?