Manual: SMA

On this page you will find the steps to connect the SMA charger to the E-Flux by Road platform.

Stef van der Meer avatar
Written by Stef van der Meer
Updated over a week ago

Configuration Requirements

  • Configuration package E-Flux by Road

    • Contains: EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station

  • Online installation & user guide manufacturer

  • Configuration device: laptop/mobile phone

Follow the steps:

Step 1: Open a browser and fill in the IP-adress of the charger

Step 2: Login with the following credentials

  • Username: operator

  • Password: service.kraft

Step 3: Go to System Überblick. Here put HTTPS on An

Step 4: Go to Netzwerk → Lan. Here put Netzwerkeinstellungen anzeigen on Anzeigen

Step 5: Go to Menu → Backend → Verbindung. Here you need to put Verbindungstyp on Enthernet

Step 6: Fill in the following OCPP settings:

  • OCPP ChargeBoxIdentity (ChargePointID): DE*342*EXXXXXXXX (Replace XXXXXXX with the serialnumber of the charger

  • OCPP Modus: OCPP-J 1.6

  • Websocket JON OCPP URL des Backends: ws://ocpp.e-flux.io/1.6/e-flux

Step 7: Go to Autorisierung → RFID-Whitelists. Here put Lokale-Whitelist & OCPP-Whitelist on An.

If you are the installer of the charging station, go to Step 8. If you are the owner of the charging station, go to step 9.

Step 8: Complete the following steps to activate the station on the E-Flux by Road platform:

  1. Login to your Field Service Account or create a Field Service Account via E-Flux by Road | Your EV charging management solution *.

  2. Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.

  3. Click on “Setup charging station”.

  4. Click on Upload Configuration, then click Next.

  5. Choose and define the connector type, and choose “Save Connector Configuration”.

  6. The charging station is now activated and ready to be registered by the owner!

*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.

Step 9: Complete the following steps to register the station on the E-Flux by Road platform:

  1. Ask your installer to complete Step 8 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.

  2. Create an E-Flux by Road account by going to E-Flux by Road | Your EV charging management solution .

    • Is this charging station facilitated by your employer? Check your email for the invitation.

  3. Follow the steps to add the location and register your charging station.

  4. Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.

  5. The charging station is now registered and ready to be used!

The charging station is now connected to the E-Flux by Road platform!

Did this answer your question?