Skip to main content
All CollectionsManuals
Manual V2C Trydan Pro
Manual V2C Trydan Pro
Franciska Buiter avatar
Written by Franciska Buiter
Updated over a week ago

Configuration Requirements

  • Configuration package E-Flux by Road

  • Contains: Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station

  • Laptop

  • UTP cable

Step 1: Create an account on V2C Cloud

Create an account on the V2C Cloud platform, either from the app or via the web.

Step 2: Pair your e-Charger

You must add your charge point in V2C Cloud.

Step 3: Access from the web platform

If accessing from the web portal www.v2c.cloud, select the OCPP section in the left-hand menu of the screen.

Step 4: the e-Chargers connected to the Internet via WiFi will appear, as OCPP only works on chargers with this connection. Click on the green pencil icon and configure the central station URL following the scheme shown below and the ID. Finally, check that the protocol has been activated in the OCPP box.

Step 5: You can add our url: ws://ocpp.e-flux.nl/1.6/e-flux, click on save.

Note: Leave the charger's OCPP ID unchanged, as changing this number may cause interruptions in the communication with the backend.

If you are the installer of the charging station, go to Step 6. If you are the owner of the charging station, go to step 7.

Step 6: Complete the following steps to activate the station on the E-Flux by Road platform:

  1. Login to your Field Service Account or create a Field Service Account via www.e-flux.io/installer-signup*.

  2. Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.

  3. Click on “Setup charging station”.

  4. Click on Upload Configuration, then click Next.

  5. Choose and define the connector type, and choose “Save Connector Configuration”.

  6. The charging station is now activated and ready to be registered by the owner!

*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.

Step 7: Complete the following steps to register the station on the E-Flux by Road platform:

  1. Ask your installer to complete Step 9 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.

  2. Create an E-Flux by Road account by going to www.e-flux.io/signup.

    • Is this charging station facilitated by your employer? Check your email for the invitation.

  3. Follow the steps to add the location and register your charging station.

  4. Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.

  5. The charging station is now registered and ready to be used!

The charging station is now connected to the E-Flux by Road platform!

Did this answer your question?