Configuration Requirements
Configuration package E-Flux by Road
Contains: Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station
Online installation & user guide THOR 11AS
Configuration device: laptop
UTP cable
Follow the steps
Step 1: After the installation of the charger is done, connect the charger to a computer via a network cable.
Step 2: Click on the Start Menu on your computer and navigate to the Control Panel.
Step 3: Click on Network and Internet and open the Properties of your current network.
Step 4: Select Internet Protocol Version 4 (TCP/IPv4) and click on Properties.
Step 5: Enter the IP address, Subnet mask and Default gateway as shown in the picture below and click on OK.
Step 6: Open the web browser on your computer and type http://192.168.1.5:8080/ in the searchbar to get access to the parameter setting page of the charger.
Step 7: Change the Server URL of the charger to ws://ocpp.e-flux.nl/1.6/e-flux
Step 8: Click on Set and Reboot to save the changes made in the configuration. After the reboot the charger will try to connect to the E-Flux by Road backend, provided the network settings are configured accordingly.
If you are the installer of the charging station, go to Step 9. If you are the owner of the charging station, go to step 10.
Step 9: Complete the following steps to activate the station on the E-Flux by Road platform:
Login to your Field Service Account or create a Field Service Account via www.e-flux.io/installer-signup*.
Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.
Click on “Setup charging station”.
Click on Upload Configuration, then click Next.
Choose and define the connector type, and choose “Save Connector Configuration”.
The charging station is now activated and ready to be registered by the owner!
*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.
Step 10: Complete the following steps to register the station on the E-Flux by Road platform:
Ask your installer to complete Step 9 to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.
Create an E-Flux by Road account by going to www.e-flux.io/signup.
Is this charging station facilitated by your employer? Check your email for the invitation.
Follow the steps to add the location and register your charging station.
Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.
The charging station is now registered and ready to be used!