Configuration Requirements
Configuration package E-Flux by Road
Contains: Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station
User Manual S-Series
Configuration device: laptop/mobile phone
Follow the steps
Step 1: Open the WiFi settings on your mobile phone or laptop and select the network that has the serial number of the charger as the SSID. The password of the network is the same as the SSID.
Note: The serial number of the charger can be obtained from the commissioning label on the right side of the charger, or from the device info on the touch screen.
Step 2: The web interface of the charger should open automatically on your device after connecting to the charger’s WiFi. If the interface didn’t open up automatically, you can log in manually by entering the following address in your browser: 192.168.1.1.
Step 3: Use the password 123456 to get access to the Main page.
Step 4: Click on OCPP setup and enter the following values:
OCPP URL: ws://ocpp.e-flux.nl/1.6/e-flux
CPID: ‘Enter the serial number of the charger’
Step 5: Select Network setup and configure one of the following Networking modes:
WiFi: Enter the WiFi Configuration (name & password) and confirm the settings
4G: Enter the APN Name (Road APN: m2m.services) and confirm the settings
Ethernet: Enter the Ethernet IP address or select DHCP and confirm the settings
Step 6: Reboot the charger.
If you are the installer of the charging station, go to Step 7. If you are the owner of the charging station, go to step 8.
Step 7: Complete the following steps to activate the station on the E-Flux by Road platform:
Login to your Field Service Account or create a Field Service Account via www.e-flux.io/installer-signup*.
Go to “Setup New EVSE” in the menu on the left and enter the serial number or OCPP ID of the station.
Click on “Setup charging station”.
Click on Upload Configuration, then click Next.
Choose and define the connector type, and choose “Save Connector Configuration”.
The charging station is now activated and ready to be registered by the owner!
*A Field Service Account is for installers only and will be used as a point of contact for technical tickets.
Step 8: Complete the following steps to register the station on the E-Flux by Road platform:
Ask your installer to complete Step 7to finish the configuration of your charger, or call E-Flux by Road to finish the configuration.
Create an E-Flux by Road account by going to www.e-flux.io/signup.
Is this charging station facilitated by your employer? Check your email for the invitation.
Follow the steps to add the location and register your charging station.
Put the sticker with the QR code on the charging station so it’s easier to identify the station if you need support.
The charging station is now registered and ready to be used!